Using dsp technology pioneered by srs these units deliver unmatched digital performance at a price below that of most conventional lock in amplifiers.
Sr810 dsp lock in amplifier manual.
The largest interfering signal is defined as the amplitude of the largest signal at any frequency that can be applied to the input before the lock in cannot measure a signal with its specified accuracy.
Voltage current sources.
Sr810 dsp lock in amplifier 1 6 displays channel 1 4 1 2 digit led display with 40 segment led bar graph.
Current input or 10 volts amp.
Sr860 dsp lock in amplifier certification stanford research systems certifies that this product met its published specifications at the time of shipment.
Y and q are available over the interface only offset x y and r may be offset up to 105 of full scale.
The sr830 simultaneously displays the magnitude and phase of a signal while the sr810 displays magnitude only.
Sr810 and sr830 dsp lock in amplifiers signal to the full scale input voltage.
Fft spectrum analyzers.
Current input 10 6 or 10 8 volts amp.
Full scale sensitivity 2 nv to 1 v in a 1 2 5 10 sequence expand off.
X r x noise aux input 1 or 2.
The sr810 lock in amplifier and sr830 lock in amplifier provide high performance at a reasonable cost.
Sr810 dsp lock in amplifier specifications signal channel voltage inputs single ended a or differential a b.
Y via interface only.
Thus in the previous example with a 2 v pk pk.
The stanford research systems sr810 and sr830 are part of the srs family of dsp lock in amplifiers.
Full scale sensitivity 2 nv to 1 v in a 1 2 5 10 sequence expand off.
Warranty this stanford research systems product is warranted against defects in materials and.
10 m ω 25 pf ac or dc coupled.
Signal recovery 7265 dual phase lock in amplifier uses the latest digital signal processing dsp technology for measurement and control of experiments.
Sr860 500 khz dsp lock in amplifier.
When the sr830 dis plays a magnitude of 1v rms the component of the input signal at the reference frequency is a sine wave with an amplitude of 1 vrms or 2 8 v pk pk.
Both instruments use digital signal processing dsp to replace the demodulators output filters and amplifiers found in.
Sr830 dsp lock in amplifier 1 5 specifications signal channel voltage inputs single ended a or differential a b.
